I did this a while back for another site, figured i would post it here as well.
Materials
Skinny sticks (popsicle sticks)
Hot melt glue gun
Paint
1st step will be marking our lenghts. take 2 sticks and mark at 2 1/2†and at 4â€. now mark on one side dots at 2/16†after each line. connect on an angle. cut all angle lines on both sticks. Mark and cut another stick at 1 inch intervals. will need two more additional 1†from another stick.
Next step you need to glue the 2 1/2†sticks and the 1 1/2†sticks in an x formation. make sure you glue them opposite of each other.
We now need to connect the two sides. I glued a 1†crossbar under the x and at the very top of chairback. see pic
Now we need to glue our four 1†sticks together with a 5th 1†across them too hold them(center it). see pic. That will be our seat. Add as many more cross bars across the chair back as you see fit for style. I used only one more.
All that is needed now is to glue the seat on and paint.
hope this helps someone
.
Materials
Skinny sticks (popsicle sticks)
Hot melt glue gun
Paint
1st step will be marking our lenghts. take 2 sticks and mark at 2 1/2†and at 4â€. now mark on one side dots at 2/16†after each line. connect on an angle. cut all angle lines on both sticks. Mark and cut another stick at 1 inch intervals. will need two more additional 1†from another stick.
Next step you need to glue the 2 1/2†sticks and the 1 1/2†sticks in an x formation. make sure you glue them opposite of each other.
We now need to connect the two sides. I glued a 1†crossbar under the x and at the very top of chairback. see pic
Now we need to glue our four 1†sticks together with a 5th 1†across them too hold them(center it). see pic. That will be our seat. Add as many more cross bars across the chair back as you see fit for style. I used only one more.
All that is needed now is to glue the seat on and paint.
hope this helps someone
.