Pulling limbs

[red4]

When pulling out elbows or ankles, it takes some doing. I've had almost a 100% success rate with this. But recently, I tried pulling out a Clone Trooper's ankle, and the peg stretched into a useless noodle. My first, and so far only limb pull failure. That pissed me off.

Go.

 

[darthdre758]

Boil and pop, sucka. Boil and pop.

 

[Goldbug]

Heat them up with a hair dryer first.

 

[red4]

I don't do either of those because they both take too long, and don't centralize on the area of interest. Too many variables can go wrong.

 

[unclassified]

dude, just hold the shit under your sink with the hot water flowing for a minute, then grab it with a shirt or something to get a good grip and pull. that simple, just heat that shit up, mane.

 

[unclassified]

microwave a cup of water for 1 minute, and there you go. if a minute is to long, then i dont know what to tell you. lol

 

[Goldbug]

I prefer the hair dryer because it is faster & no need to use any water.
Just use it on high for 30 seconds. If it doesn't come out easy then blow more hot air on it.

 

[K-Tiger]

Indeed. Heat and pull. I've broken a few by being a lazy fuck and not using heat.

 

[Cloud Strife]

I prefer the hair dryer because it is faster & no need to use any water.
Just use it on high for 30 seconds. If it doesn't come out easy then blow more hot air on it.

^^This

 

[Meddatron]

Summer I boil hot water in microwave, winter, I just set the figure by a running heat vent or space heater.

 

[Dr Syn]

Cannot be said enough, heat with a hair dryer or boiling water, anything else and expect a broken joint/part.

 

[Dropshipbob]

Another problem you run into with not boiling/heating/popping is potentially ruining the joint.

Hate. That.