Cougar #5......

Digler

Officer
Officer Club
Nov 28, 2012
819
88
28
Vancouver,BC Canada
www.facebook.com
Just got the last of my special ordered materials for Azlogans Cougar. I'm going to be putting my first wheel sculpt for the heavier military equipment, rather that using the PTE APC wheels. I'll have some pics up next week. This should be done in March sometime. 11537621_1466431683655006_280092502211017896_o.jpg11226074_1466446336986874_6936575044387055148_o.jpg
 

G.I.*EDDIE

gobbles a LOT of cock
Founder
Mar 14, 2011
43,432
428
83
S.E. Mich :(
This is what you need. The insta set is awesome!

 

Digler

Officer
Officer Club
Nov 28, 2012
819
88
28
Vancouver,BC Canada
www.facebook.com
These are my own original sculpts.....since I just can't find the right wheel for these vehicles....I'll make them. They are not perfect...but they will work well. I've been casting these for about a week as I was not satisfied with the casts at all......these will work. This has been a little delay because of time.....but pitter patter.
IMG_5500.JPGIMG_5501.JPGIMG_5502.JPGIMG_5503.JPG
 

KASCAN

New member
Jan 23, 2018
8
1
3
Central Florida
www.facebook.com
What are you using to fab the molds? Are you injecting the resin? Are you using a lube on the molds or using temp to separate cast from mold? Are you doing straight time on setting resin or accelerating with heat and/or mix hot?
 

pcsguy88

Deuce Deuce
Staff member
Mar 14, 2011
12,421
635
113
KC
www.fighting118th.com
Lube is always the right answer.

Digler, when are you flying to Chiner to get some of these things mass produced? You could single handedly get me back into collecting if I could buy your vehicles for a $150 or under and they didn’t shatter if dropped.
 

Digler

Officer
Officer Club
Nov 28, 2012
819
88
28
Vancouver,BC Canada
www.facebook.com
What are you using to fab the molds? Are you injecting the resin? Are you using a lube on the molds or using temp to separate cast from mold? Are you doing straight time on setting resin or accelerating with heat and/or mix hot?
Hey KS, molds are from Alumalite#3 mold. nothing to separate casts, they come out pretty easy. The resin only takes 5mins to set.
 

Digler

Officer
Officer Club
Nov 28, 2012
819
88
28
Vancouver,BC Canada
www.facebook.com
Lube is always the right answer.

Digler, when are you flying to Chiner to get some of these things mass produced? You could single handedly get me back into collecting if I could buy your vehicles for a $150 or under and they didn’t shatter if dropped.
Yes that would be nice.....we'll see if we can give the community here a kick in the ass and come and post and share and make customs again.... yes when you drop them they shatter, they are models....LOL I'd like to get the MRATT Kickstarted.