Do you make flex chute to feed this?
Yes we are and the first sets are coming out great.
I use a rubber fuel line for the discharge chute. .
I have the Pickel minigun without the separate barrels. I'd like to make it one piece and then remold it so there would be the gun, flexible ammo belt, and 3 part arm mount.
The separate barrel version may be the version I cast in place of this. Everything would be the same as the one above except the barrels would look like Pickel's updated version.
I have the Pickel minigun without the separate barrels. I'd like to make it one piece and then remold it so there would be the gun, flexible ammo belt, and 3 part arm mount.
The separate barrel version may be the version I cast in place of this. Everything would be the same as the one above except the barrels would look like Pickel's updated version.
Looks amazing, but is it possible to keep the barrels the same thickness all the way to the muzzle?
There are 2 different sized barrels, fat to skinny giving it a tapered look. It's also hard to usually see, but there's a 7th barrel that goes down the center of the 6 smaller barrels on the end. I'm guessing it's for structural support for the smaller barrels and to hold the rings in place since it doesn't run the length of the gun.
Maybe just need to shrink the spacing so the barrels are closer together?
Yes I could do that easily
I'm not bitching. I'm gonna buy some either way. But the piano wire barrels at the end seem a little thin. Looking at the picture, I can see the taper, but I think the brass tube the full length of the barrel would be closer. PLUS it has a hole at the end and looks like an actual barrel.
Any benefit to brass over casted other than durability?
Oh, it can spin too.